How to Wash a Ceiling Without a Ladder

Most ceilings are too high to reach without a ladder. Luckily, you can wash your ceiling with just an old broomstick and some soapy water! Just put the broomstick under the ceiling, hold it there with one hand, dip your other hand in the bucket of soapy water, and scrub away. Make sure to avoid any electrical wiring or pipes that may be running through your walls or ceilings.

How to Wash a Ceiling Without a Ladder

It’s also recommended to wear gloves for this job because it is quite dirty work! Some people recommend using a squeegee for this task as well. You can find them at most hardware stores if you don’t already have one handy! So, this article is for you. You will learn how to wash a ceiling without a ladder with just one simple trick!

6 Steps to Follow on How to Wash a Ceiling Without a Ladder

Step One: Get your ceiling fan out of the way.

You are removing your electric ceiling fan. Be sure you use a ladder for this; remember that safety is key. The last thing you want to do is get up there and fall off of the ladder! Instead, get yourself two wrenches- one to take the screws out of the canopy and one to take the screws out of your ceiling fan.

Remove Your Ceiling Fan

Turn the power off to your ceiling fan. If you have a light kit attached, unscrew that too, then take it down with you. If you just have a ceiling fan, then get that out of the way too. Sometimes you will have to cut power to the ceiling fan, depending on where your main switch is.

Step Two: Take your ceiling light down

You want to make sure you don’t drop anything. If it’s easier, take all of the bulbs out of the fixture. Next, take the glass shade off that is on top of the lightbulb, then unscrew it from there. You may have to support this part with a ladder if it’s too heavy for you. Next, unscrew the metal plate that holds it in place.

Remove Your Ceiling Light

If you have a light socket on your fixture, be careful when you take it out of its housing. You don’t want to break the wires or anything. You need a vacuum cleaner and a mop bucket now that you have taken your light fixture down.

Step Three: Get rid of the dust.

Use warm water with dish soap to clean your ceiling. Be sure to wipe it down with a rag and run the water over that as well, then use paper towels to dry off your ceiling after that. If you don’t clean all of this up immediately, dust will fall from your ceiling and settle back onto your light fixtures.

Suck up all of that dust with your vacuum cleaner. First, use the hose to get into the areas you couldn’t otherwise reach, and be sure to check your fan blades while you’re at it. Next, go back over all of it with a mop bucket and rag. Make sure to get rid of any leftover soap suds, too.

Step Four: Inspect your ceiling fan

You can’t put your ceiling fan back up if you’re not sure the wiring is still good. This depends on how old your system is or whether it’s been updated recently. Look at the wiring on your light fixture and see if it is bare or old rubber insulation. If any of this wire looks bad, you’ll have to replace it before putting anything back up.

Some older installations will have a fuse in between the fan and the light, so be sure to check for that while you’re at it. Ask an electrician what you should do if you need help. If there is nothing, be sure to remove any debris in your light fixture while you are up there.

Step Five: Reassemble your ceiling fan

First, put back the metal plate- screwing it into place with the screws included with your ceiling fan kit. Next, put the lightbulb and light shade back on, but only tighten them as much as necessary- you don’t want to break any of the glass down there! As long as they aren’t wobbling, you should be fine.

Reassemble Your Ceiling Fan

Now place your ceiling fan back up where it belongs, and put the screws back in place. Tighten them carefully with the second wrench before plugging your fan back into the wall socket. If you have a light kit, attach it back to the fan before putting your glass shade back on. This will help in how to wash a ceiling without a ladder.

Step Six: Put your light fixture up.

This part is much like taking it down- only in reverse! Take the screws holding your metal plate in place out with your first wrench. Screw that into place, then hold onto it with your second wrench while reattaching the fixture to the metal plate.

You may want to have a friend or family member help you with this, but try not to have them hold it up for too long! Your glass shade should go back on next. Have a third hand if possible- someone helping you can hold it in place while you screw it in with your own hands.

Turn the power back on after you’re done, and test all of your lights to make sure they come on. Well, there you have it! If you’ve never thought about washing your ceiling before, now might be a good time to start thinking about doing so, if only for the safety factor alone.

Conclusion

Inform readers that the best way to clean a ceiling is by using a long pole with an extension brush. Inform readers of using this technique and why it works better than trying to get onto a ladder or chair. 

Suggest that if they do not have access to such equipment, they should attempt dusting their ceilings without getting on them to avoid any accidents while ascending/descending the ladder. The article has been a good guide on how to wash a ceiling without a ladder.

Check it out to learn- How to Fix Sagging Ceiling in Mobile Home

Smart Home Pick
Logo